![]() ![]() This provides an installation using the mainline kernel and U-Boot. Pacman-key -populate archlinuxarm AArch64 Installation Initialize the pacman keyring and populate the Arch Linux ARM package signing keys:.Login as the default user alarm with the password alarm.Use the serial console or SSH to the IP address given to the board by your router.Insert the SD card into the Raspberry Pi, connect ethernet, and apply 5V power.Move boot files to the first partition:.Download and extract the root filesystem (as root, not via sudo):īsdtar -xpf -C root.Write the partition table and exit by typing w.Type n, then p for primary, 2 for the second partition on the drive, and then press ENTER twice to accept the default first and last sector.Type t, then c to set the first partition to type W95 FAT32 (LBA).Type n, then p for primary, 1 for the first partition on the drive, press ENTER to accept the default first sector, then type +200M for the last sector.This will clear out any partitions on the drive. At the fdisk prompt, delete old partitions and create a new one:.Replace sdX in the following instructions with the device name for the SD card as it appears on your computer. Use this installation if you require any of the vendor's kernel hacks, overlays, or closed-source GPU blobs and utilities. Using an insufficient power supply will result in random, inexplicable errors and filesystem corruption. A power supply rated at 2.5A is the official recommendation. Note: The Raspberry Pi 3 has higher power requirements than the Raspberry Pi 2. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |